4G UltraDIAL Battery Alarm with a Wireless BT PIR & Vibration Door Window Contact

4G UltraDIAL battery powered Covert IP66 Standalone Wireless GSM Alarm supplied with:

• 1 x BT-PIR (007-0200).
• 1 x Magnetic Contact & Vibration Sensor (007-1460).
• 2 x Remote Controls (007-0240).

How it Works:

The 4G UltraDIAL, PIR & Magnetic Vibration Contact are all connected to each other within a unique & secure Wireless Network, and all are Armed & Disarmed at the same time using either Remote Control.

If the PIR or Magnetic Contact (on a door or window) detects an Intruder, it will silently trigger the UltraDIAL Alarm before activating the Siren inside the PIR & Vibration Sensor (if this has been selected).

During this time the 4G UltraDIAL will be secretly contacting key-holders by Telephone & SMS.

If additional PIR's or Sirens are added to the system (no limit), they would all sound at the same time. 

The secret of using this Alarm is to hide (or lock) away the UltraDIAL in a location where an Intruder wouldn't even know it is there (if this is not possible then try to position it well out of reach), this is very easy due to the fact it is Battery powered, Wireless & Fully Weatherproof.

This simple Alarm is ideal for so many applications, examples are:

• Workshop (UltraDIAL hidden away out of sight).
• Shed or small Garage (UltraDIAL hidden away out of sight).
• Caravan (UltraDIAL hidden in a cupboard, outdoor storage hatch, under a bed).
• Boat (UltraDIAL hidden inside the cabin, cupboard, engine hatch).
• New Builds or Renovations (UltraDIAL hidden into a loft space, locked cupboard).
• Rental or Temporary Homes (UltraDIAL hidden out of sight and reach).
• Show & Exhibition Stands (UltraDIAL hidden out of sight and reach).
• The list is endless !!

Communication:

The Alarm communicates via the mobile phone networks (nano sim card required).

It will contact up to three key-holders by Telephone (with your own pre-recorded message) & Text Message when activated.

This Alarm uses a nano sim card, we recommend using a SIM Card with a Network from the Country that the device will be used.

Additional Wireless PIR's & Sirens:

The Alarm can be paired to various wireless devices (no limit) which have built in Sirens, these will make the sound whilst the Covert UltraDIAL silently calls the key-holders without an Intruder knowing, the Wireless range between the UltraDIAL & accessories is an impressive 300 ft (line of sight) allowing you to protect more than one building if required.

These Sirens & devices include:

• Indoor Battery Siren (007-0230).
• Outdoor Solar or Battery Siren & Strobe (007-0221).
• Standard PIR (007-0200).
• Standard PIR with Hood (007-1410).
• Door Contacts (007-0260) & (007-1460).

BT PIR:

The battery powered PIR (007-0200) supplied has a built in 130 Decibel Siren, with a 30 second Exit Delay & 5 second Entry Delay. Its detection range is 24 ft with a horizontal coverage of 120 degrees and vertical of 90 degrees.

BT Wireless Vibration & Magnetic Door or Window Contact:

It has a host of features including:

• Optional Vibration Sensor (with adjustable sensitivity settings).
• Optional Magnetic Contact operation.
• Built in Keypad (can be used to Arm & Disarm).
• Can be Armed & Disarmed by the Remote Controls in the kits.
• Optional built in 130 decibel Siren (can be turned off) operates for 30 seconds.
• Optional Door left Open 'Beep' mode (whilst in disarm mode). 
• Optional Door left Open 'Alarm' mode (whilst in Armed state).
• Easy to Fit Magnet.
• It can also be used as a stand-alone Alarm.

You can choose to use the device with Vibration Only, Magnetic Contact Only or with both Enabled.

When used as a Magnetic Contact on a Window or Door, one part would be fitted onto the Door/Window and the other part onto the Frame (in such a position that when closed both parts are nearly touching).

Keypad:

The device has a small keypad that is used to carry out the choice of commands to suit your application together with being able to Arm & Disarm the complete Alarm system in the event you have forgot to carry the relevant Remote Control.

Arming & Disarming:

The Alarms are Armed & Disarmed by using the 2 x Remote Controls (supplied) from up to 300 ft away, up to 9 Remote Controls can be used with each Alarm. 
If the UltraDIAL Alarm is powered by the external 5v power source, then it is possible to Arm & Disarm the Alarm via SMS (text message).There is a 30 second Exit Delay built into the Alarm for easy use.

Contacting Key-holders:

The Alarm will contact between 1 & 3 key-holders (depending on how you have chosen to program the alarm) by Telephone & SMS (either can be turned off whilst programming the alarm) when activated.

It will normally take take between 30 - 60 seconds to call the first key-holder when powered by battery, and quicker when powered by a plug in transformer or usb cable (this can vary depending on the mobile phone networks at the time).  

Recording Message:

You can record a 30 second message into the Alarm, which will be replayed to the key-holders when the Alarm calls them.

Power Supply:

The UltraDIAL Alarm is powered by 3 x Lithium AA Batteries (supplied) which will last around 6 months in most applications, it can also be powered by a 5v Plug in Transformer or USB Cable where a power supply is available. If the power supply is used, the batteries can be kept in the Alarm as a backup although they will not be charged by the device.

The BT PIR (007-0200) is powered by 3 x AA Duracell Batteries. 

Receiving a Call:

When the Alarm calls the key-holders, there is the choice to:

• Listen to your pre-recorded message and do nothing (the alarm will contact the other key-holders).
• Listen to your pre-recorded message and press # on your telephone (this will disarm the UltraDial and prevent it from calling further key-holders).
• Listen to your pre-recorded message and press * on your telephone (this will prevent it from calling further key-holders, but keep the Alarm fully armed (ready for further activations).

Wireless Alarm Detectors:

Additional Wireless Detectors can be added to this versatile Alarm, they have a wireless operating range of 300 ft (line of sight), which equates to around 120 - 150 ft in most applications. Many customers will protect two, three or even four buildings located next to each other with one system.

The options include:

• Battery PIR's with Built in Sirens (007-0200).
• Battery PIR's with a Hood & Siren (007-1410).
• Battery UltraPIR's, can be used without the SIM Card but in Silent Mode (007-0360).
• Battery Wireless Door Contact (007-0260) & (007-1460).

Wired Alarm Detectors:

The UltraDIAL has one momentary volt free Input, 1 x N/O or N/C, these can be used with many types of devices, examples listed below:

Normally Open going Closed:

• Water & Flood Sensors.
• Alarm Panel.
• Perimeter Beam.
• Pressure Mat.
• Tilt Switch.

Normally Closed going Open:

• Door Contact.
• Gate Contact.
• Alarm Panel.
• Pressure Mat.
• Tilt Switch.

Easy Programming:

The UltraDIAL is very easy to program, probably the easiest GSM Alarm to program on the market today by using the small built in keypad, following some very simple instructions.

Weatherproof:

The UltraDIAL is fully weatherproof and rated at IP66, so can be used in most locations, it is not however designed to be submerged.

Low Battery:

The UltraDIAL Alarm will send the primary key-holder a SMS (text message) if the batteries are getting low.

Status Report:

A status report can be obtained by sending the device a Text Message.

Mains Power Failure:

When the Alarm is being powered by an external 5v power supply, it will send the primary key-holder a SMS (text message) in the event of a Power Cut together with another when the power comes back on (provided you also have batteries fitted).  

Security Screws:

The lid is fitted with 4 x security screws and a tool is supplied as standard.

This is a very versatile Security device ideal for many applications designed by Ultra Secure Direct.

If you need advice, please Contact Us !!

• 1 x 4G UltraDIAL GSM Alarm.
• 1 x BT PIR.
• 2 x Remote Controls.
• 3 x Lithium AA Batteries.
• 3 x AA Alkaline Batteries.
• 1 x Manual.
• 1 x Tool.
• 1 x Wireless Vibration & Magnetic Contact.
• 1 x Magnet.
• 1 x Set of Double Sided Tape.
• 2 x Screws.
• 1 x CR2 Lithium Battery.

UltraDIAL:

• Battery Power: 3 x Lithium AA Batteries (supplied).
• Battery Life: 6 months in most applications).
• Main Power: Yes (optional 5v DC plug in transformer).
• Programming Method: Easy Built in Keypad.
• Operates on 4G, 3G & 2G Networks.
• Wireless Transmission Range: 300 ft.
• Size: 6 1/4" x 3 1/4" x 1 3/4".
• Colour: Black.
• Wired Inputs: Yes (1 x Volt Free N/O or N/C).
• Cable Entry: 2 x Glands.
• Wireless Inputs: Yes (Wireless PIR's & Door Contacts).
• Wireless Outputs: Yes (Internal & External Sirens, PIR's).
• SIM Card Required: Yes (nano size).
• Calls Key-holders: Yes (maximum of three, which can be turned off).
• Sends Key-holders SMS: Yes (maximum of three, which can be turned off).
• Built in Siren: No (designed as a covert alarm).
• Mounting Method: 2 x Screw Holes in Flange.
• Weatherproof: Yes (IP66).
• Arming & Disarming Method: Remote Control, Keypad, Receiving A Call.
• Remote Operation on Battery: Yes (# to Disarm, * to Stop & Remain Armed).
• Remote Operation on Mains:  Yes (# to Disarm, * to Stop & Remain Armed, SMS to Arm, SMS to Disarm).
• Power Failure Notification: Yes (when used with a plug in transformer).
• Weekly Status Report: Yes (can be turned off).
• Low Battery Notification: Yes (to primary key-holder).
• Recording Message: Yes (this will be replayed to the key-holders when the alarm calls them).
• Frequencies:
• LTE-TDD B38/B40/B41
• LTE FDD B1/B3/B5/B7/B8/B20/B28
• UMTS/HSPA+ B1/B8
• GSM/GPRS/EDGE 900/1800 MHz

PIR:

• Alarm Detection Type: PIR (passive infrared detector).
• Hood: Yes (rubber).
• Arming & Disarming Method: Remote Control.
• Working Distance between PIR & Remote Control: 300 ft (line of sight).
• Transmission Distance to additional Wireless Sirens: 300 ft (line of sight).
• Built in Siren: Yes (130 decibels).
• Exit Delay: Yes (30 seconds).
• Entry Delay: Yes (5 seconds).
• Siren Duration: 60 seconds (remains fully armed, until disarmed by remote control).
• Detection Range: 24 ft.
• Detection Horizontal Coverage: 120 Degrees (with front of hood fully opened up).
• Detection Vertical Detection: 90 Degrees (with front of hood fully opened up).
• PIR Power Supply: 3 x AA Batteries (supplied).
• Remote Control Power Supply: 1 x 3v Lithium Coin Battery.
• Size of PIR: 2 3/4" x 4 1/4" x 1 1/2".
• Size of Remote Control: 3" x 1 3/4" x 1/2".
• PIR Battery Life: 12 - 18 months (normal use).
• Warranty: 1 Year.

Vibration Sensor:

• Wireless Operation with UltraDIAL Alarms: Yes.
• Wireless Operation with BT PIR Alarms: Yes.
• Wireless Range: 300 ft (line of sight).
• Internal Siren: Yes 130 Decibel (optional, can be turned ON or OFF).
• Vibration Sensor: Yes (optional). 
• Magnetic Contact: Yes (optional).
• Vibration Sensitivity Adjustment: Yes (low, medium & high).
• Duration of Siren: 30 seconds. 
• Keypad Code Change: Yes (cannot start with 3).
• Keypad To Arm: Yes (press 3). 
• Keypad To Disarm: Yes (code + 3).
• Exit Delay: 20 seconds.
• Entry Delay: 5 seconds.
• Change Code Option: Yes.
• Size of Contact: 21/4" x 1 1/2" x 5/8".
• Size of Magnet: 1 3/4" x 1/2" x 1/2".
• Power Supply: Battery (1 x 3v Lithium CR2 Battery).  
• Colour: White.
• Open Door Beep: Yes Optional (when disarmed).
• Open Door Siren: Yes Optional (when armed).
• Test Mode: Yes (beep on open & close with 30 second reset.
• Stand-alone Operation: Yes.
• Frequency to Wireless Sirens 868 Mhz.

Remote Control:

• Operating Range: 300 ft (line of sight).
• Arm & Disarm Function: Yes.
• SOS Function: Yes (UltraDIAL).
• Size: 2 1/2" x 1 1/2" x 1/2".
• Key Ring Slot: Yes.
• Battery:1 x CR2032H.
• Pairing Button Location: Inside Battery Cover.
• Colour: White & Black.